Ultraviolet HVAC Air Duct Sterilizer Model 999-2 - Dual tube

The biggest concern office buildings is air quality. This makes in-duct HVAC air purification a nobrainer in terms of disinfection. Air contaminants are brought in by workers and visitors from outside the building, and microbes can also breed inside the building on cooling coils and in air ducts.


TechMed UV HVAC Air Duct mountable fixtures are easy to mount and are offered in one and two UV tubes configuration. Improves Indoor Air Quality by serving as a UV-C air sterilizer thus considerably reducing bacteria, viruses and mold that either grow or pass through the air handling systems, also reduces the risk of cold, Seasonal flu, common allergies and other illnesses associated with air contamination. When exposed in the HVAC duct, UVC light Continuously cleans coils, drain pans, plenums and ducts, eliminating costly cleaning programs and the use of harmful chemicals and disinfectants, it also considerably Reduces HVAC energy costs by restoring heat transfer and net cooling capacity.


Model 999-2

Material : Epoxy coated MS Steel & SS304
Tube Construction : Water proof Epoxy sealed contacts
Tubes : 254nM Wavelength, Single Tube/Dual Tube
Duct Type : Sheet Metal or Fiberboard ducts
Size : 7 Inch x 2 Inch x 5 Inch (LxBxH) Metal Body
Tube Length extension in Air Duct - 10 Inch
Mounting : 35mm x 35mm cut in the Air Duct, flange mount
Power Switch : Yes
Cable Length : 2 Meters
Power Usage : 13/ 25 Watt max
Power Supply : 230/110 VAC 50/60 Hz

Ideal Application

  • Works Ideal for Central Air Condition or Central Heating Air Duct application.
  • Widely used in Hospitals, Commercial & Industrial establishment

Installation Guide Simple easy to install

TechMed manufacturers wide range of standard and custom Ultraviolet UV Air Sterilizer for HVAC air ducts, our simple design allows you to install the Ultraviolet UV-C Air cleaning unit into existing Air ducts in 15 minutes.


First Step

Select the Ultraviolet UV Light unit mounting location and mark the dimension to be cut


Second Step

Cut the mark area on the Air Duct, so the UV tube can be inserted into the Air Duct


Third Step

Drill 3 mm diameter holes on the marked mounting area on the Air Duct.


Fourth Step

After the mounting holes are drilled, the unit can be inserted into the Air Duct.


Fifth Step

Fastern the screws of the UV-C outdoor unit flanges.


Sixth Step

Once the unit is assembled, you are ready to start Air & Surface Disinfection using UV-C light. Power up and use ON/OFF switch to use